LG PQRCVSL0, Owners & Installation Manual

Owner’s & Installation Manual 

25

E

N

G

L

IS

H

24

New Wide Wired Remote Controller

Installation Instructions

Installation Instructions

Function Code

Zone Number installed

Press        repeatedly until it shows 
Function code 14.

Ex) Setting the Zone Number for "2"

2

Select Zone Number by pressing       
button
(02~04 : number of zone installed)

3

Press         button to save or release.

4

1

Pressing and holding the        button for 
3 seconds enters the remote 
controller setup mode. If it is 
not held for 3 seconds, it enters 
the user setup mode. 

Pressing the        button will exit 
the settings mode. If        is not 
pressed, the remote controller will 
automatically exit setup mode after 25 
seconds with no input. If the set button is 
not pressed, the changes will not take 
effect. 

5

Installer Setting - Zone Number Setting

This function is only available on some products. 
Zone Number is to set the number of installed zones. It is possible to control only in zone new type

Installer Setting - Emergency Heater Setting

This function is only available on some products
This function will set the Emergency Heater Setting.
Emergency Heater  is used to heat the space in emergency case such as heat pump error. 
Emergency heat is in place of and does not supplement heat pump.

※

Emergency  Heater setting Function sets following conditions:
1) Emergency Heater operation while in error or outdoor unit  operates  cooling cycle.
2) Emergency Heater operation in Low Ambient temperature
3) Fan speed setting during Emergency Heater operation

This function setting must be carried out by a certified-technician.
Incorrect function setting can cause fire.

CAUTION

Function Code

Setting1: Heater Operation while in error or 
 

outdoor unit operates cooling cycle.

Press        repeatedly until it shows 
Function code 18.

2

Select mode of Heater Operation while 
in error by pressing              button

00: not use
01: use 

Ɠ

If 00 is set at this stage, setting 2 and 
setting 3 will not be available

3

Setting2 : Low Ambient 
Heating Operation

Setting3 : FAN Speed 
Setting during Emergency 
Heater Operation

Setting1 : Heater 
Operation while in error  
or outdoor unit operates 
cooling cycle.

1

Pressing and holding the        button for 
3 seconds enters the remote 
controller setup mode. If it is 
not held for 3 seconds, it enters 
the user setup mode.