Downloaded from Projector.com
Installing and Composition
12
Installation and Composition
Provide proper ventilation for this projector.
●
The projector is equipped with ventilation holes(intake)
on the bottom and ventilation holes(exhaust) on the front.
do not block or place anything near these holes, or internal
heat build-up may occur, causing picture degradation or
damage to the projector.
Place this projector in adequate temperature and humidity conditions.
●
Install this projector only in a location where adequate temperature and humidity is available. (refer p.27)
●
Do not place the projector on a carpet, rug or other
similar surface. It may prevent a adequate ventilation
of the projector bottom. This product should be
mounted to a wall or ceiling only.
* Don’t place the projector in the following conditions. It may cause malfunction or product damage.
●
Never push projector or spill liquid of any kind into the
projector.
●
Leave an adequate distance(30cm/12 inches or
more) around the projector.
Don’t place the projector where it can be covered with dust.
●
This may cause overheating of the projector.
Do not obstruct the slots and openings of the projector. This may cause overheating and create a fire
hazard.
The projector is manufactured using high-precision technology. You may, however, see tiny black points
and/or bright points (red, blue, or green) that continuously appear on the projector Screen. This is a nor-
mal result of the manufacturing process and does not indicate a malfunction.
To display DTV programs, it is necessary to connect a DTV receiver (Set-top Box) and connect it to the
projector.
If there is no input signal, the Menu will not be displayed on screen.
Installation Instructions
This product should be used adequate length bolt(within 5mm) when installing it.
When applying a ceiling installer, use only the fixing bolt and ceiling installer for pro-
jector. Contact your dealer for purchase or installation.
TP-ML2
TP-MH2
This Manual: http://www.manuallib.com/file/2698438
Summary of Contents for RD-JT91
Page 30: ......
