2
Connecting
Connecting
12
Connecting
2
Wireless subwoofer
connection
LED indicator of wireless subwoofer
LED Color
Status
Yellow green
(Blink)
Attempting to make
connection.
Yellow green
The connection is completed.
Red/
Yellow green
(Blink
alternately)
The wireless subwoofer
connection is initialized.
Off
(No display)
The power cord of wireless
subwoofer is disconnected.
Setting up the wireless subwoofer for
the first time
1. Connect the power cord of the wireless
subwoofer to the outlet.
2. Turn on the main unit : The main unit and wireless
subwoofer will be automatically connected.
Manually pairing wireless subwoofer
When your connection is not completed, you can see
the red LED or the blinking of yellow-green LED on
the wireless subwoofer and the subwoofer does not
make sound. To solve the problem, follow the below
steps.
1. Adjust volume level of the main unit to minimum
by pressing
VOL
p
button repeatedly until
standby LED on the main unit blinks slowly.
2. Press and hold
(Mute) on the remote control
for about 3 seconds.
-
The standby LED on the main unit blinks
quickly.
3. If the LED of the wireless subwoofer
already
blinks in yellow-green continually, you can skip
this step.
Press and hold
PAIRING
on the back of the
wireless subwoofer for more than 5 seconds.
-
The LED of the wireless subwoofer lights up
alternately in red and yellow-green.
4. Disconnect the power cord of the main unit and
the
wireless subwoofer.
5. Connect them again after the LED of the main
unit and the wireless subwoofer is fully turned
off.
The main unit and the wireless subwoofer will be
paired automatically when you turn on the main
unit.
-
When the connection is completed, you can
see the yellow-green LED on the subwoofer.
y
It takes a few seconds (and may take longer)
for the
main
unit and the subwoofer to
communicate with each other and make
sounds.
y
The closer the
main
unit and the subwoofer,
the better sound quality. It is recommended
to install the
main
unit and the subwoofer as
close as possible and avoid the cases below.
-
There is a obstacle between the
main
unit
and the subwoofer.
-
There is a device using same frequency
with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.
,
Note
