Connecting
17
C
onnecting
2
Wired Network Setup
If there is a DHCP server on the local area
network (LAN) via wired connection, this unit will
automatically be allocated an IP address. After
making the physical connection, a small number
of home networks may require the unit’s network
setting to be adjusted. Adjust the [NETWORK]
setting as follow.
Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Connection Setting] option in the
[Setup] menu then press
Center button
.
2. The [Connection Setting] menu appear on the
screen. Use
W/S
to select the [Wired] and
press
Center button
.
3. Use
W/S/A/D
to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using
W/S/A/
D
.
,
Note
4. Select [OK] and press
Center button
to apply
network settings.
5. The unit will ask you to test the network
connection. Select [OK] and press
Center
button
to complete the network connection.
6. If you select [Test] and press
Center button
at
step 5 above, the network connection status is
displayed on the screen.
You can also test it on the [Connection Status]
in the [Setup] menu.
