30
206-4310
Ez Download Utility (Cont.)
(Continued from previous page)
10. When you are ready to continue, use the arrow keys on the Installer Remote to select
UPDATE
,
and then press
OK
.
Update progress will be shown in a new screen. Do NOT remove the USB device while
updates are in progress. When the Ez Download process is complete, an overview of the
results will briefly be displayed and then, the STB will reboot.
11. Remove the USB memory device, and verify that the appropriate configuration/update(s) is/are
resident on the STB.
Note:
If you updated the STB configuration with a
Clone/Configuration
file, upon restart (and, if
applicable, confirmation of new video output resolution—see note below), the STB tunes according
to the Start Channel setting in the Installer Menu. If a Start Channel is specified, the STB will
tune to that channel
, though in the case of FTG Mode configuration, a channel banner will only
be displayed if the Start Channel is included in the FTG Channel Map (depending on your selection
in step 9, the channel banner will display either the Start Channel’s logical channel number or
physical RF channel number). Otherwise, the STB will either return to the last channel tuned (STB
in Pass-through Mode) or tune to the first channel in the FTG Channel Map (
STB in FTG Mode).
In the latter case, remember that the channels in the FTG Channel Map are always arranged in
logical order, regardless of your selection in step 9.
Note:
If you updated the STB configuration with a
Clone/Configuration
file that included a change
to Installer Menu item 105 VID OUT FORMAT, when the reboot is complete, you will be prompted to
confirm the new video output resolution
. See item 105 description on page 39 for further information.
