LG TD-V75120E, Use And Care Manual

I

nstallation Instructions

9

Prior to the first use of this appliance, use all-purpose
cleaning products or a solution of detergent and
water, with damp clothes to remove from the inside of
the dryer drum/drying compartment any dust or dirt
that may have accumulated in the inside of the dryer.
Plug-in your dryer after reviewing the following parts
on your dryer’s Electrical Requirements.

Close the door to the dryer drum/drying
compartment and, after completing all steps in this
manual for proper installation of this dryer, start the
dryer on a heat setting, as described more fully in
the operating instructions that accompany the dryer.
The exhaust air or the exhaust pipe should be warm
after the dryer has been operating for three minutes.

The following instructions are applicable to 
installations of the dryer in a manufactured or mobile 
home. If you are uncertain whether your proposed
installation will comply with these standards, please 
contact a service and installation professional for
assistance.

STEP 4

Preparation of the Dryer

Following are several warnings and instructions
concerning making the electrical connection for
electric dryers.

STEP 4

Electrical Plug Connections

STEP 5

Confirming Heat Source
Operation

STEP 6

Additional Instructions
for Installation of Your
Dryer in a Manufactured
or Mobile Home

The following instructions apply to any installation
of the dryer in a manufactured or mobile home:

1) Electric dryers may be vented to the outside

using the back left or right.

2) The dryer exhaust duct must be fixed securely

to the manufactured or mobile home structure,
and the exhaust duct must be made of a material
that will resist fire and combustion, and it is
recommended that you use a rigid or flexible
metal pipe.

3) Make sure the dryer has adequate access to

outside fresh air to ensure proper operation. The
opening for outside fresh air must be at least 163

4) It is important that the clearance of the duct from

any combustible construction be at least 5cm, 
and, when venting the dryer to the outdoors, the 
dryer can be installed with a clearances of 1 inch 
at the sides and back of the dryer.

7) DO NOT connect the exhaust duct with any other

duct, vent, chimney, or other exhaust duct.

8) Make sure the dryer has adequate access to

outside fresh air to ensure proper operation. The
opening for outside fresh air must be at least 25
in (163 ).

7) Please be aware that venting materials are not

supplied with the dryer. You should obtain the
venting materials necessary for proper
installation.

DO NOT connect exhaust ducts with
metal screws or fasteners that extend
into the duct.

DO NOT vent the exhaust duct under the
manufactured or mobile home.

WARNING!

Do not pulg with several other appliances power cord.
Do not grasp power cord or switch with wet hands.
Do not use damaged power cord, plug and socket.

Use power supply (Socket) rated 230Volts 
15 ampere.

WARNING!

WARNING!

Installation

Instructions