12
INSTALLATION
Connecting the Hose to the
Appliance
Screw the water inlet hose to the water inlet valve
on the back of the appliance.
• Do not connect the hose to the hot water supply
for models with one water inlet. Connect to the
cold water supply only.
NOTE
• After completing connection, if water leaks from
the hose, repeat the same steps. Use the most
conventional type of tap for the water supply. In
case that the tap is square or too big, remove the
guide plate before inserting the tap into the
adaptor.
Installing the Drain Hose
Before connecting the drain hose, check your drain
hose model and choose the correct instruction.
Installing the Drain Hose
without the Elbow Bracket
1
Push the elbow hose toward the body of the
appliance.
2
To change the direction of the hose, pull out
the elbow hose and change the direction.
Repeat Step 1.
Positioning the Drain Hose
• The length of the drain hose should not exceed
300 cm
. Do not place the drain hose more than
6
cm
above the threshold.
• The outlet of the drain hose should not be
submerged in water.
• Make sure the drain hose is not kinked.
Levelling the Appliance
Checking the Level
Levelling the appliance prevents unnecessary
noise and vibration. Check whether the appliance is
perfectly level after installation.
FP
FP
Summary of Contents for TH2112DSAV
Page 9: ...9 INSTALLATION ENGLISH Dimension mm W 540 D 540 H 945 D 560 H 1250 H H D D W ...
Page 39: ...Memo ...
Page 40: ......