18
Installation
Installation
3
Setting an ID of wireless receiver
When the unit is manufactured, the ID is
already set. If an interference occurs or you
use a new wireless receiver, an ID should be set
again.
1.
Turn on the main unit and turn off the
wireless receiver.
2.
Press and hold
x
(STOP) on the front of unit
and MUTE on the remote control. “REMATE”
appears in display window.
3.
Turn on the Wireless Receiver. A new ID is
set.
NOTE
If there is a strong electromagnetic wave
product nearby, interference may occur. Put the
unit (Wireless Receiver and main unit) away from
there.
If there is no audio signal for longer than 10
minutes, the Wireless Receiver will automatically
switch to standby mode. In power saving mode,
both LEDs will turn red. LEDs will turn blue when
there is any audio signal back.
If you operate main unit then wireless speakers
(rear speakers) sound within a few seconds in
standby mode.
Set the distance between this unit and Wireless
Receiver within 10 m (32 ft.).
Optimum performance can be implemented
only when the Wireless Transmitter and the
Wireless Receiver within distance of 2 m (6 ft.) to
10 m (32 ft.) is used since communication failure
may occur if longer distance is used.
Be sure to match the speaker cable to the
appropriate terminal on the components: + to +
and – to –. If the cables are reversed, the sound
will be distorted and will lack bass.
It takes a few seconds (and may take longer) for
the Wireless Transmitter and Wireless Receiver to
communicate with each other.
Use the rear speaker at least 30 cm (11 inch)
away from either TV screen or PC monitor.
•
•
•
•
•
•
•
•
About Ferrite Core (for EMI only)
Be sure to attach the ferrite core to the speaker
cable (for connecting to this unit and wireless
receiver). This ferrite core can reduce noises.
How to attach the ferrite core
1.
Press the stopper [a] of the ferrite core to
open.
2.
Wind the speaker cables once on the ferrite
core.
3.
Close the ferrite core until it clicks.
Refer to the fi g.3 and comment.
The length
here is as
short as
possible.
Rear of wireless
receiver
HB905TAW-FH.BNZLLLK_ENG_0854.ind18 18
HB905TAW-FH.BNZLLLK_ENG_0854.ind18 18
2010.5.28 3:47:49 PM
2010.5.28 3:47:49 PM