9
Installation
■
Installation place requirements
▶
Location
•
Level floor :
Allowable slope under entire washer is 1°.
•
Power outlet :
Must be within 1.5 meters of either side of location
of washer. Do not overload the outlet with more
than one appliance.
•
Additional Clearance :
For Wall, 10cm:rear / 2cm : right & left side.
Do not place, store or use laundry products on top
of washer at any time.
They can damage the finish or controls.
▶
Positioning
•
Install the washer on a flat hard floor.
•
Make sure that air circulation around the washer is not impeded by carpets, rugs, etc.
•
Never try to correct any unevenness in the floor with pieces of wood, cardboard or similar materials under the
washer. Do not build the machine into a closed cupboard.
•
If it is impossible to avoid positioning the washer next to a gas cooker or coal burning stove,an
insulating(85x60cm) covered with aluminum foil on the side facing the cooker or stove,must be
inserted between the two appliance.
•
The washer must not be installed in rooms where the temperature can drop below 0°C.
•
Please ensure that when the washer is installed, it is easily accessible for a Service Technician in the event of
a breakdown.
•
With the washer installed, adjust all four feet using the transit bolt spanner provided ensuring the
appliance is stable, and a clearance of approximately 20 mm is left between the top of the washer
and the underside of any work-top.
•
This equipment is not designed for maritime use or for use in a mobile installations such as caravans,
aircraft etc.
•
It is also not intended for commercial or outdoor applications, or washing of items such as foot ware,
mats etc.
Washer
approx.
2cm.
