9
ENGLISH
_inde
x
ENGLISH
_inde
x
-
Other unspecified walls must be
capable of supporting pullout loads
of over 70 kgf (686 N) and shear
loads of over 100 kgf (980 N) per
fastener.
-
Use an Ø 8 mm drill bit for
concrete and a hammer (impact)
drill or Ø 4 mm drill bit for wood
stud to drill holes.
(For installation on concrete wall)
Anchors for fixing the wall mount
Screws for fixing the wall mount
a. Drill holes in anchor locations with a
drill bit of Ø 8 mm to a depth of 80
mm to 100 mm.
b. Clean the drilled holes.
c. Insert the enclosed anchors for
fixing the wall mount into the holes.
(Use a hammer when inserting
anchors.)
d. Push the wall mount support closely
toward the wall to match the hole
locations.
e. Tighten screws for fixing the wall
mount to the holes. At this time,
tighten the screws with the torque
more than 45 kgf/cm to 60 kgf/cm.
Summary of Contents for WB21EB
Page 20: ......