9
INSTALLATION
EN
G
LI
SH
Installing the Oven and Test
Run
Unpacking and Removing Oven
Doors
WARNING
• Keep packing materials out of the reach of
children. Packaging material can be dangerous
for children. There is a risk of suffocation.
• You should use two or more people to move and
install the appliance. (Excessive Weight Hazard)
Failure to do so can result in back or other injury.
• Do not use the door handles to push or pull the
appliance during installation or when moving
the appliance out for cleaning or service. Doing
so can result in serious damage to the door of
the appliance.
• To reduce the risk of burns, do not move this
appliance while it is hot.
NOTE
• To remove any remaining tape or glue, rub the
area briskly with your thumb. Tape or glue
residue can also be easily removed by rubbing a
small amount of liquid dish soap over the
adhesive with your fingers. Wipe with warm
water and dry.
• Do not use sharp instruments, rubbing alcohol,
flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the
surface of your appliance.
• Door removal is not a requirement for
installation of the oven, but is an added
convenience.
Unpacking Materials
Remove any packing material from the oven
before installing the oven.
1
Remove all tape from around the oven.
2
Open the oven door and remove packaging
materials and oven racks inside the oven.
Removing Lower Oven Door
1
Fully open the door.
2
Unlock the hinge locks, rotating them as far
toward the open door frame as they will go.
a
Slot
b
Hinge lock
c
Hinge arm
3
Firmly grasp both sides of the door at the top.
4
Close the door to the removal position
(approximately five degrees
d
) which is
halfway between the broil stop position and
fully closed. If the position is correct, the
hinge arms will move freely.
5
Lift door up and out until the hinge arm is
clear of the slot.
6
Place the oven on a table or platform even
with the cutout opening. The table or
platform must support 202 lbs (92 kg) for a
combination wall oven.
NOTE
• Use two hands to remove lower oven door.
• Do not lift the door by the handle. The oven door
is very heavy. Firmly grasp the door by the sides
before lifting it off the hinges.
• Do not lay the oven door on its handle. Doing so
may cause dents or scratches.
Electrical Requirements
Ensure that dedicated circuit protection is
prepared as recommended and that the appliance
is grounded properly.
us_main.book.book Page 9 Thursday, December 9, 2021 8:44 AM
