LG WDES9428F, Installation Manual

12

INSTALLATION

Installing the Oven and Test 

Run

Unpacking and Removing Oven 

Doors and Bottom Trim

WARNING

• Keep packing materials out of the reach of 

children. Packaging material can be dangerous 

for children. There is a risk of suffocation.

• You should use two or more people to move and 

install the appliance. (Excessive Weight Hazard) 

Failure to do so can result in back or other injury.

• Do not use the door handles to push or pull the 

appliance during installation or when moving 

the appliance out for cleaning or service. Doing 

so can result in serious damage to the door of 

the appliance.

• To reduce the risk of burns, do not move this 

appliance while it is hot.

NOTE

• To remove any remaining tape or glue, rub the 

area briskly with your thumb. Tape or glue 

residue can also be easily removed by rubbing a 

small amount of liquid dish soap over the 

adhesive with your fingers. Wipe with warm 

water and dry.

• Do not use sharp instruments, rubbing alcohol, 

flammable fluids, or abrasive cleaners to remove 

tape or glue. These products can damage the 

surface of your appliance.

• Door removal is not a requirement for 

installation of the oven, but is an added 

convenience.

Unpacking Materials

Remove any packing material from the oven 

before installing the oven.

1 

Remove all tape from around the oven.

2 

Open the oven door and remove the 

packaging materials and oven racks inside the 

oven.

Removing Oven Door

1 

Fully open the door.

2 

Unlock the hinge locks, rotating them as far 

toward the open door frame as they will go.

a

Slot

b

Hinge lock

c

Hinge arm

3 

Firmly grasp both sides of the door at the top.

4 

Close the door to the removal position 

(approximately five degrees 

d

) which is 

halfway between the broil stop position and 

fully closed. If the position is correct, the 

hinge arms will move freely.

5 

Lift door up and out until the hinge arm is 

clear of the slot.

NOTE

• Use two hands to remove the oven door.
• Do not lift the door by the handle. The oven door 

is very heavy. Firmly grasp the door by the sides 

before lifting it off the hinges.

• Do not lay the oven door on its handle. Doing so 

may cause dents or scratches.

Removing Metal Bottom Trim

1 

Place the oven on a table or platform even 

with the cutout opening. The table or 

platform must support 190 lbs (86 kg) for a 

single built-in oven, 325 lbs (147 kg) for a 

double built-in oven.

2 

Remove the metal bottom trim from the oven. 

It will be installed at the end of the installation 

œš†”ˆ•U‰––’U‰––’GGwˆŽŒGXYGG{œŒš‹ˆ SGqœ“ GY^SGYWYXGGYaYXGwt