1
-
2
-
INSTALLATION
1
Remove pedestal, installation hardware, and
instructions from the shipping carton.
2
Position the washer/combo on top of the pedestal.
NOTE :
Because of the weight of the
washer/combo, two or more people
may be needed.
NOTE :
If the washer or combo was previously
installed, unplug it, disconnect the inlet
hose (s) from the faucet (s), disconnect
the drain hose, and drain all hoses.
3
Remove the paper from the
bracket.
4
Attach the double-faced tape of the bracket to the
washer/combo as shown so the bent parts of the
brackets align with the edge and can be attached
to the pedestal with screws.
NOTE :
Attach the lower side first.
5
Be sure to press the adhesive parts of the brackets
firmly to the appliance.
6
Install the eight (8) screws (supplied) to attach the
brackets to the pedestal.
7
Move the washer/combo to the desired place.
NOTE :
The appliance and pedestal assembly
must be placed on a solid and level floor
for proper operation. Adjust the legs of
the appliance and pedestal by turning
with a wrench. Then, adjust the lock nut
toward the pedestal while holding the
pedestal leg using a wrench.
Excessive Weight Hazard
Two or more people may be needed to install and
move the appliance and pedestal assembly.
Do not allow children to play on the drawer.
Do not step on the handle.
W
WA
AS
SH
HE
ER
R // C
CO
OM
MB
BO
O IIN
NS
ST
TA
AL
LL
LA
AT
TIIO
ON
N
WARNING
for washer/
combo
for washer/
combo
for dryer
for dryer
