18
INSTALLATION
• Tighten the fittings securely. Turn on both
faucets all the way and check for leaks at
both ends of the hoses.
Connecting the Drain Hose
Connect the drain hose to either a standpipe or
laundry tub.
WARNING
• The drain hose should always be properly
secured. Failure to properly secure the drain
hose can result in flooding and property
damage.
NOTE
• The drain must be installed in accordance with
any applicable local codes and regulations.
• Make sure that the drain hose is not stretched,
pinched, crushed, or kinked.
• The end of the drain hose should be located a
minimum of
24" (61 cm)
and a maximum of
96"
(244 cm)
above the bottom of the washer. For
best results, locate the end of the drain hose no
higher than
66" (168 cm)
above the bottom of
the washer. As the drain outlet is raised beyond
66" (168 cm)
, the drain function will be
increasingly affected.
• If you are experiencing backflow or residual
water in the dryer reservoir, try reducing the
height of the dryer drain hose end to lower than
38" above the base of the washer.
• Never create an airtight seal between the hose
and the drain with tape or other means. If no air
gap is present, water can be siphoned out of the
drum resulting in poor wash/rinse performance
or clothing damage.
Connecting the Drain Hose to the
Dryer
1
Remove the stamped area on the middle of
the bracket to make an opening for the drain
hose of the dryer.
2
Insert the hose clamp
a
onto the drain hose
of the dryer.
3
Connect the drain hose of the dryer and
secure the hose clamp.
4
Loosen the screw
b
on the stack bracket.
5
Screw in the band to secure the drain hose of
the dryer onto the stacking bracket.
6
Use the provided tie strap
c
to secure the 2
drain hoses in place.
Summary of Contents for WKHC202H A Series
