ENGLISH
17
REMOTE CONTROL
The descriptions in this manual are based on the buttons on the remote control. Please read this manual carefully to
use the Signage webOS Box correctly. To install batteries, open the battery cover, place batteries (1.5 V AAA) matching
and terminals to the labels inside the compartment, and close the battery cover. To remove the batteries,
perform the installation actions in reverse. The illustrations may differ from the actual accessories.
CAUTION
•
Do not mix old and new batteries, as this may damage the remote control.
•
Be sure to point the remote control toward the remote control sensor on the Signage webOS Box.
•
Some features of the remote control may not be supported in certain models.
",#
(POWER)
Turns the Signage webOS Box on or off.
Turns the Signage webOS Box on.
Turns the Signage webOS Box off.
Adjusts the brightness of the picture to reduce energy
consumption.
(INPUT)
Selects the input mode.
* Used for viewing 3D videos.
Toggles between numerical and alphabetical.
Number and Alphabet buttons
Enters numerical or alphabetical characters depending upon the setting.
Deletes the entered numerical or alphabetical character.
*
Volume Up/Down Button
Adjusts the volume.
Selects the Aspect Ratio mode.
*
Automatically adjusts picture position and minimizes image instability
(available for RGB input only).
*
(MUTE)
Mutes all sounds.
Adjusts the brightness of the display. (PAGE function is not
supported in this model.)
