36
TROUBLESHOOTING
Operation
Symptoms
Possible Cause & Solution
Appliance will not
operate.
Control panel has powered off due to inactivity.
• This is normal. Press the
POWER
(ENCENDIDO/APAGADO)
button to turn
on the appliance.
Appliance is unplugged.
• Make sure that the cord is plugged securely into a working outlet.
Water supply is turned off.
• Turn on the water supply tap completely.
Controls are not set properly.
• Make sure the cycle is correctly set. Close the door and press the
START/PAUSE
(INICIO/PAUSA)
button.
Circuit breaker/fuse is tripped/blown.
• Check house circuit breakers/fuses. Replace fuses or reset breaker. The
appliance should be on a dedicated branch circuit. The appliance will
resume the cycle where it stopped once power is restored.
Control needs to be reset.
• Press the
POWER
(ENCENDIDO/APAGADO)
button, then reselect the
desired programme and press
the
START/PAUSE
(INICIO/PAUSA)
button.
START/PAUSE was not pressed after a cycle was set.
• Press the
POWER
(ENCENDIDO/APAGADO)
button, then reselect the
desired cycle and press the
START/PAUSE
(INICIO/PAUSA)
button. If the
START/PAUSE
(INICIO/PAUSA)
button is not pressed within a certain
time, the appliance will be turned off.
Extremely low water pressure.
• Check another tap in the house to make sure that household water
pressure is adequate.
Appliance is too cold.
• If the appliance has been exposed to temperatures below freezing for an
extended period of time, allow it to warm up before pressing the
POWER
(ENCENDIDO/APAGADO)
button.
Appliance is heating the water or making steam. (some models only)
• The drum in the appliance may stop operating temporarily during certain
cycles, while water is safely heated to a set temperature.
Detergent is not
dispensed completely
or not dispensed at all.
Too much detergent is used.
• Follow the guidelines provided by the detergent manufacturer.