Help Hot Line (U.S. only): 1-800-530-9960
6-21
D-620605-0-20 Rev A
CONFIDENTIAL
Fusion SingleStar Installation Procedures
Figure 6-6
System Configuration Window
9.
Select the operating bands from the Select Band pull down menu.
The operating bands must match the band of the RAUs that are used in the sys-
tem.
10.
Change the System Gain in the text boxes, if desired.
The default is 0 dB for both the uplink and downlink.
11.
Change the System Label, if desired.
The default is “Fusion”.
12.
Click
OK
.
During configuration, which can take several minutes for a fully-loaded system
(that is, 8 RAUs), all disconnect status are cleared; the frequency band, gain, and
system label are set; logs are cleared; the system test is performed; and finally the
status tree is refreshed. The icons should be:
Indicating that the bands are correctly set.
Indicating that communications are OK.
If there are problems, the icons are different and a message is displayed in the
Messages pane.
NOTE:
Refer to Section 8 for troubleshooting.
