Help Hot Line (U.S. only): 1-800-530-9960
6-13
D-620605-0-20 Rev A
CONFIDENTIAL
Fusion SingleStar Installation Procedures
• Carrier (for multiple operator systems)
To connect the CATV cables:
1.
Connect the CATV cables to the F ports according to the labels on the cables.
The
STATUS
LEDs should be off because the RAUs are not connected at the other
end of the CATV cable.
2.
Record which cable you are connecting to which port (that is, from the label on
the cable).
This information is required for the As-Built Document.
3.
Tie-off the cables or use the optional cable manager to avoid damaging the con-
nectors because of cable strain.
6.4.1.1
Troubleshooting with Hub LEDs During Installation
• All Fusion SingleStar Hub
PORT
LEDs, with corresponding RAUs connected,
should indicate Green, which indicates that the RAU is powered on and communi-
cation has been established.
• The Fusion SingleStar Hub
STATUS
LED should be red if the band has not been
programmed.
Table 6-5
Troubleshooting Fusion SingleStar Hub LEDs During Installation
During
Installation
LED
State
Action
Impact
1.
Fusion Sin-
gleStar Hub
power is On
and no
RAUs are
connected
POWER
Off
Check AC power; check that the
Hub power-on switch is on;
replace the Hub.
The Hub is not powering on.
Red
Replace the Hub
One or more power supplies
are out of specification.
PORT
LEDs on but didn’t
blink through all states
Replace the Hub.
The Microcontroller is not
resetting properly; flash
memory is corrupted.
PORT
Red (60 ppm flashing)
Port unusable; replace the Hub
when possible.
Current sensor fault; do not
use the port.
PORT
Red
Use AdminBrowser to determine
the problem.
The Hub is off-line.
