The radiator is not coming on
Manual radiator:
Make sure the plug is turned on at the wall.
Turn the temperature up by turning the dial to a higher number or until the
red light comes on.
Wireless control:
Make sure the plug is turned on at the wall.
Put the controller in the sun setting and increase the temperature by one or
two degrees.
Make sure the controller is linked to the receiver, if the green light on the
radiator is blinking, then you need to perform the initial setup.
Make sure the radiator is not in manual mode, if the yellow light on the
radiator is showing, press the button on the radiator receiver until the
yellow light is no longer showing.
Make sure that the controller is in a position where it can measure the
temperature of the room (in the same room as a radiator), and between 1m
and 1.5m from the floor.
Controller is locked
Press and hold the ok button, and simultaneously press the minus button
to unlock and lock the controller.
Programs are different for different days
If you make a change to the programming, and you would like to have
this change for everyday in the week, then you will need to make the
change for each day.
Please see the choosing a program section.
Summary of Contents for Radiator
Page 1: ...LHZ USER GUIDE ...