17
MAINTENANCE
Wheels
:Wheels should be centered in the fork or dropouts. If you hear any irregular noise from the wheels or
brakes, the wheels should be checked and repaired. Regularly check the spokes of the wheels for tightness
and rim alignment. The wheels should rotate smoothly without wobbling from side to side. Check the
bearing play of the hubs by lifting the bicycle and spinning the wheel, It should continue to spin for several
turns after your stop spinning. To check the play of the hubs try to move the rim from side to side between
the forks. No substantial play should exist. If you detect play or if the wheel is difficult to turn, the bearings
must be adjusted or replaced. Please contact a local bicycle dealer to have the hub bearings adjusted or call
800-806-7109 for new bearings.
Throttle
: Your throttle is on the right hand side of your handlebars. It is a variable speed throttle. To increase
the speed, turn the throttle towards you (counterclockwise) while seated on the bike. There is an automatic
SHUT OFF of the throttle on the brake levers. Every time the brake lever is pressed, the power from the
motor is discontinued.
Rims
: The rims should be smooth and without cracks, breaks or bulges
Spokes
: Check the tension of the spokes regularly. About the same tension should be on all the spokes. If there
is some minor loosening of the spokes, you may tighten the nipples, but it is recommended that you take it to
a bicycle mechanic. If there is a loose spoke or if the rim has side play of more than 1/8” (4mm),
immediately have the wheel trued by a bicycle mechanic or call (800) 806-7109. Riding with loose spokes
may cause the wheel to fail!
Tires
: Inflate your tires to the pressure embossed on the sidewall before use of your new bike. It is
recommended that the tire pressure for your Liberty Electric Bike is at least 40 psi. Every time you ride,
make sure the tires are inflated according to the pressure on the sidewall. Improper tire pressure will make
riding more difficult, cause excessive wear, and premature failure of the tire. The tire should be properly
seated in the rim and the fitting of the tire bead and rim bead should be checked. If the tube is pinched
between the rim and the tire, it will fail when inflated. Make sure that the tire is not cracked or worn
unevenly. Check for bulges. Check and make sure that the valve stem is straight in the rim. Irregular tires
should be replaced immediately.
Handlebar and Display
: We have created the handlebar display so that you can easily see it while riding. To
straighten the handlebars, turn the stem binder bolt to loosen it and straighten the handlebars so they are
.
