2
Introduction
Safety Information
Please read, understand, and follow all safety instructions. Failure to follow
instructions may result in property damage, serious injury, or death.
DANGER
Always
disconnect power prior to moving, adjusting, or servicing pump or attached
systems.
DO NOT
use this pump in the presence of spraying or standing water.
Failure to do so could result in a fatal electric shock.
WARNING: Fire and Explosion Hazard
DO NOT
use this pump to move flammable or explosive liquids.
DO NOT
use this
pump in explosive or flammable environments.
Ensure that pump is mounted away from heat exchanger or wiring. If you are unsure
of any items in this manual, please consult a professional and
DO NOT
attempt to
install this product.
CAUTION: Flood Risk
Personal injury or property damage can result from an inoperative pump. If a flood
has occurred,
DO NOT
walk in wet area until all power has been turned off. Check
with local electric company or a qualified electrician before disconnecting any
electrical service prior to pump removal.
WARNING
Pump must be properly wired to condensate producing appliance control board in
order to shut off appliance in alarm (high water) conditions.
Supply voltage and frequency must match what is shown on pump nameplate.
Source voltages lower than the rated supply can reduce performance and cause
pump to overheat.
Pump must be level and should be mounted to, or placed on, a solid surface or
floor.
DO NOT
cover pump air vents. Pump is air cooled.
DO NOT
cover vent holes
located on top or sides of the pump housing. Pump may be operated continuously
as long as air vents are not covered.
Pump should be installed indoors. The chosen location should be clean and dry.
This pump is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the pump
by a person responsible for their safety. Children should be supervised to ensure that
they do not play with the pump.
Temperature Rating (not tested for hot water)
• Continuous duty 140˚F
• Max inlet temperature 160˚F
• Not suitable for contact with steam or gases that exceed 160˚F
This pump should be installed by HVAC/R trained service professionals.
