Page
14
of
15
The bottom of the nose can now be glued
in place. Trim off the bottom of the motor
bulkhead so that it is flush with the
bottom of the nose.
The receiver can be attached to the velcro
inside the fuse after plugging in the servo
wires and binding to the transmitter.
Move your battery forward or back inside
the fuse to get the right CG. The CG is at
the spar in the top wing, or 2-1/2” from
the leading edge of the upper wing at the
root or center of wing. After plugging the
battery in, the connector and wires can be
hidden by pushing them down through the
hole.
