background image

LIBRESTREAM ONSIGHT 2500  

REGULATORY AND SAFETY GUIDE

SCOPE

This manual applies to the following models.  
References to MCD2500 in this manual, apply to  
all the listed models below.

•  MCD2500 
•  MCD2500

GENERAL SAFETY INFORMATION

•  

Do not attempt to service or dismantle this  
equipment. All repairs must be done by an  
authorized Librestream service depot.

•  

Contact support for an authorized Librestream 
service depot.

•  

Do not block or insert objects into any openings 
in the equipment. Doing so may damage internal 
components and may cause fire or shock hazards.

•  

Carefully read the Librestream Quick Start Guide 
and the User manual before operating the Onsight 
2500, paying special attention to “Operating 
Environment” in section 10.

•  

Use only a Librestream-supplied power adapter 
with the equipment. Use of other adapters may 
cause fire or explosion hazards.

•  

Operate the external power adapter in a well 
ventilated area. Do not cover the power adapter 
with papers or any other items as the adapter may 
become hot.

   

 

This symbol appears within this manual, 
as well as the User Manual, Quick 
Start Guide, and on the product label.  
The symbol means “Attention, consult 
ACCOMPANYING DOCUMENTS”.  This is 
a critical symbol and the user must refer 
to the accompanying documents.

1.1. BATTERY

CAUTION! RISK OF EXPLOSION IF BATTERY IS 
REPLACED BY AN INCORRECT TYPE OR INSTALLED 
INCORRECTLY.

•  

Observe the correct polarity when changing the 
lithium battery. Install battery according to the 
manufacturer’s product documentation.

•    Replace battery only with the same type as  

recommended by the manufacturer

•  

Dispose of used batteries according to the 
manufacturer’s product documentation and local 
disposal requirements

•  

Use only Librestream-supplied batteries with the 
Onsight 2500. Use of other types may increase 
the risk of fire or explosion or damage to the 
equipment.

•  

Do not store the battery in places where metallic 
objects may come in contact with the battery 
terminals (e.g. in a pocket with keys, in a drawer 
with paper clips, etc.). The resulting short-circuit 
can cause extremely high temperatures that may 
damage the battery and cause burns or fires.

•  

Do not attempt to disassemble the battery. The 
battery poses a burn hazard if handled improperly. 
Immediately dispose of a damaged or leaking 
battery.

•  

Do not store or leave the Onsight 2500 or Onsight 
2500 battery near a heat source (e.g. radiator, 
stove, heater, automobile dashboard, etc.) as the 
battery may explode or ignite.

1.2. BATTERY DISPOSAL

The Onsight 2500 uses a Lithium-Ion battery and 
must be disposed of properly:

•  

The battery must not be disposed with household 
or office waste.

•  

Do not dispose of the battery in a fire as the 
battery may explode.

•  

Contact your local waste disposal agency for the 
address of the nearest battery disposal location.

1.3. SAFETY NOTICE

The Onsight 2500 mobile streaming camera (Model 
MCD2500) was evaluated to IEC 60950-1:2001, 
EN60950-1:2001, UL 60950-1:2003 and CSA C22.2 
60950-1:2003 standards and found to be in  
compliance with the standard requirements.

 

U8 09 09 61052 011

1.4. SAFETY NOTICE (FOR USE IN CANADA ONLY)

The Onsight 2500 mobile streaming camera (Model# 
Onsight 2500), complies with UL60601-1:1st edition 
and CAN/CSA C22.2 601.1-M90 ONLY when used  
in conjunction with the power supply model no. 
UE24WCP-120150SPA.

 

U8 09 10 61052 012

1.5. AC ADAPTER INFORMATION

This device is supplied with an AC Adapter for 
charging the battery and powering the Onsight 2500. 
The following labels identify the safety approvals for 
the AC Adapter.

For use only in Canada

1.6. FCC RF EXPOSURE NOTICE

For body worn operation, this product has been tested 
and meets RF exposure guidelines when used with an 
accessory that contains no metal. Use of other  
accessories may not ensure compliance with RF  
exposure guidelines. No metallic accessories should 
be used with this device and multiple devices should 
not be co-located at a distance of less than 20 cm.

Warning: Changes or modifications not expressly 
approved by the manufacturer could void the user’s 
authority to operate this equipment.

1.7. INDUSTRY CANADA RF NOTICE

Under Industry Canada regulations, this radio 
transmitter may only operate using an antenna of a 
type and maximum (or lesser) gain approved for the 
transmitter by Industry Canada. To reduce potential 
radio interference to other users, the antenna type 
and its gain should be so chosen that the equivalent 
isotropically radiated power (e.i.r.p.) is not more than 
that necessary for successful communication.

Conformément à la réglementation d’Industrie  
Canada, le présent émetteur radio peut fonctionner 
avec une antenne d’un type et d’un gain maximal  
(ou inférieur) approuvé pour l’émetteur par Industrie 
Canada. Dans le but de réduire les risques de 
brouillage radioélectrique à l’intention des autres 
utilisateurs, il faut choisir le type d’antenne et son 

Declares under sole responsibility, that the 
product(s) as originally delivered:

Product Name:   

Onsight Mobile Device

Model Number(s): 

MCD2500-XXX

complies with the essential requirements of the  
following applicable European Directives and 
carries the CE marking accordingly:

Low Voltage Directive (2006/95/EC) 
EMC Directive (2004/108/EC) 
R&TTE Directive (1999/5/EC) 
ATEX Directive (94/9/EC)  
*this directive applies to Onsight 2500Ex only

and conforms to the following harmonized  
standard(s):

EMC & RADIO:  EN 55011:2007 CLASS B 
EN61000-6-2:2005, EN61000-3-2:2006,  
EN61000-3-3:2008 
ETSI EN 300 328 V1.8.1:2012 
ETSI EN 301 893 V1.7.1:2012 
ETSI EN 301 489-1 V1.8.1:2008 
ETSI EN 301 489-17 V1.2.1:2009 
EN 50360 :2001, EN 50371:2002, EN 50392:2004

SAFETY:

EN 60950-1+A1:2010, IEC 60950-1+A1:2009

ATEX:

EN 60079-0:2006, EN 60079-11: 2012  
EN 60079-15:2010 (Onsight 2500Ex only)

Supplementary Information /  
Information Supplémentaire:

France :

L’utilisation de cet équipement (avec 2.4GHz 
Wireless LAN) est soumise a certaines restrictions: 
Cet équipement peut être utilisé à l’intérieur d’un 
bâtiment en utilisant toutes les fréquences entre 
2400 a 2483.5MHz (Chaîne 1-13). Pour l’utilisation 
en environnement extérieur, toutes fréquences entre 
2454-2483.5MHz doivent être désactivés. Voyer les 
instructions inclus pour configuration extérieure de 
cet équipement. Pour les dernières restrictions, voir 
http://www.art-telecom.fr

For 2.4 GHz Wireless LAN operation of this product, 
certain restrictions apply: This equipment may 
be used indoor for the entire 2400-2483.5 MHz 
frequency band (channels 1-13).  For outdoor use, 
the frequency band from 2454-2483.5 MHz must be 
disabled. Please see included instructions on how to 
configure the product for outdoor use in France.  For 
the latest restrictions, see http://www.art-telecom.fr

Place of Issue: Winnipeg MB. Canada 
Date of Issue: May 23rd, 2013

 

gain de sorte que la puissance isotrope rayonnée 
équivalente (p.i.r.e.) ne dépasse pas l’intensité 
nécessaire à l’établissement d’une communication 
satisfaisante.

This device complies with Industry Canada licence- 
exempt RSS standard(s). Operation is subject to 
the following two conditions: (1) this device may not 
cause interference, and (2) this device must accept 
any interference, including interference that may 
cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie 
Canada applicables aux appareils radio exempts  
de licence. L’exploitation est autorisée aux deux  
conditions suivantes : (1) l’appareil ne doit pas 
produire de brouillage, et (2) l’utilisateur de 

l’appareil doit accepter tout brouillage radioélectrique 
subi, même si le brouillage est susceptible d’en 
compromettre le fonctionnement.

LICENSE EXEMPT RADIO APPARATUS / APPAREILS 
RADIO EXEMPTS DE LICENCE

The device for operation in the band 5150-5250 
MHz is only for indoor use ONLY, this restriction is 
to reduce the potential for harmful interference to 
co-channel mobile satellite systems.

Les dispositifs fonctionnant dans la bande  
5150-5250 MHz sont réservés uniquement pour  
une utilisation à l’intérieur afin de réduire les risques 
de brouillage préjudiciable aux systèmes de satellites 
mobiles utilisant les mêmes canaux.

High-power radars are allocated as primary users 
(i.e. priority users) of the bands 5250-5350 MHz 
and 5650-5850 MHz and these radars could cause 
interference and/or damage to LE-LAN devices.

Les utilisateurs de radars de haute puissance sont 
désignés utilisateurs principaux (c.-à-d., qu’ils ont  
la priorité) pour les bandes 5250-5350 MHz et  
5650-5850 MHz et ces radars pourraient causer 
du brouillage et/ou des dommages aux dispositifs 
LAN-EL.

The maximum antenna gain permitted for devices 
in the bands 5250-5350 MHz and 5470-5725 MHz 
shall complies with the e.i.r.p. limit.

Le gain maximal d’antenne permis pour les dispositifs 
utilisant les bandes 5250-5350 MHz et 5470-5725 
MHz conforme à la limite de p.i.r.e.

The maximum antenna gain permitted for devices  
in the band 5725-5825 MHz complies with the  
e.i.r.p. limits specified for point-to point and non  
point-to-point operation as appropriate.

Le gain maximal d’antenne permis (pour les  
dispositifs utilisant la bande 5725-5825 MHz)  
conforme à la limite de p.i.r.e. spécifiée pour  
l’exploitation point à point et non point à point,  
selon le cas.

CE DECLARATION OF CONFORMITY

CE Declaration of Conformity (DOC) is shown on 
following page. The signed copy of the Declaration of 
conformity is available; please contact Librestream 
customer support if you require a signed copy.

  

DECLARATION OF CONFORMITY

  

According to ISO/IEC 17050-1:2004 

Manufacturer’s Name: 

Librestream Technologies Inc. 

Manufacturer’s Address: 

895 Waverley St. Suite 110  
Winnipeg, MB. R3T 5P4 
Canada. T: 204-487-0612, F: 204-487-0914

Reviews: