6
STABILIZERS / LEVELING FEET
When the battery cabinet is located in its final position before or after wiring, it is
necessary to fit stabilizer brackets and, if necessary, adjust the leveling feet. If
the UPS is wired using a rigid wiring system, then movement of the UPS must be
prevented by winding down the 4 leveling feet under the UPS as shown below.
For UPS wired with flexible cables, this is optional.
Adjust the leveling feet as necessary using a 12mm open-ended wrench. DO
NOT LOOSEN THE LARGER NUT ABOVE, AS THIS FIXES THE LEVELING
FEET TO THE CHASSIS.
Attach the stabilizing brackets as follows.
GXT240VBATT or GXT240VBATTUL models:
1. Using a Phillips-head screwdriver, remove the screws (4) from each of the
bottom corners of the side panels.
2. Attach the stabilizing brackets to each corner using screws just removed.
GXT240VLRT or GXT240VLRTUL models:
1. Using a Phillips-head screwdriver, remove the two inner-most screws at the
base of both side panels.
2. Attach the stabilizers fixing with the screws just removed.
Leveling Feet Adjustment Diagram
240VBATT
240VLRT
12 mm
