24/59 Gebruikershandleiding / User Manual / Bedienungsanleitung
HAL,
rev. 1.2:17-05-2019
Operation and use of HAL-200 ER
1. Check that the HAL-200 is properly assembled and that the switch is in the OFF-
position.
2. Place the HAL-200 in the direct vicinity of where you are going to smoothen the
surface of the
the concrete floor.
3. Put the plug of the drive-
unit’s feeder cable in the wall socket.
4. Place the HAL-200 on the surface of the freshly poured concrete, and turn the speed
regulator slowly to the required revolutions.
5. Now start to smooth the surface of the concrete floor by moving the HAL-200
backwards in a slow but steady motion.
6. After having finished one lane of concrete, switch of the HAL-200 by turning the
speed regulator’s knob to the position
–MIN-
, You will hear a
“CLICK”. Tip:
If the
processed concrete-surface is not smooth enough, repeat the procedures
4, 5 and 6.
7. Pull the plug of the feeder cable out of the wall socket.
8. Clean the machine with water and a brush.
9. After use, place the HAL-200 on a dry and stable surface.
5.3. Use of HAL-200 with petrol engine
WARNINGS:
o
Do not run the engine in a closed area. Exhaust gas contains carbon monoxide, an
odourless and deadly poison.
o
Gasoline is extremely flammable and can be explosive under certain conditions. Stop
engine and allow the engine to cool off before refueling.
o
When refuelling or working on the carburetter / fuel circuit, make sure the area is well
ventilated, do not smoke and stay away from any source of flame or sparks. Do not
fill the tank so the fuel level rises into the filler neck or level surface of the level
gauge. If the tank is overfilled, heat may cause the fuel to expand and overflow
through the vents in the tankcap. Wipe off any spilled gasoline immediately.
o
Keep the engine at least 1 mtr. away from buildings, obstructions and other burnable
objects. To avoid getting an electric shock, do not touch the spark plug or spark plug
lead during engine running.
o
To avoid a serious burn, do not touch a hot enginemuffler. Before you service or
remove parts stop engine and allow the engine to cool down.
o
Always remove the spark plug lead from the spark plug when servicing the engine to
prevent accidental starting.
Starting
Summary of Contents for HAL200 H
Page 44: ...44 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 48: ...48 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 54: ...54 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 56: ...56 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
