25/59 Gebruikershandleiding / User Manual / Bedienungsanleitung
HAL,
rev. 1.2:17-05-2019
Adjust the switch on the engine to “START”. Pump petrol until fuel comes out of the
overflow pipe. Close the choke (if the outside temperature is high or the engine is still warm,
the choke can be opened halfway or completely). Open the gas halfway.
Careful:
Do not pull the starter rope all the way and allow it to runback slowly.
If the engine runs with a closed choke, you can carefully move the choke handle to the
“OPEN” position. If the engine does not start in this way, you can repeat the procedure with
the choke in “OPEN” position.
Allow the engine to run for approx. 3 minutes before you can set the throttle handle to the
desired engine speed.
If the engine does not start, do not repeat the procedure with the choke in closed position too
often. This to prevent that too much fuel comes into the cylinder which makes starting more
difficult. Simply open the choke completely and restart the engine. Vary the number of
revolutions of the engine with the gas throttle to remove air from the carburetor. Do not allow
the engine to run on maximum number of revolutions before 3 minutes of warming-up have
passed.
Smoothing the concrete floor
1. Start to smooth the surface of the concrete-floor by moving the HAL-200
backwards in a slow but steady motion.
2. Repeat this procedure if the processed concrete-surface is not smooth or level
enough.
3. Switch of the machine; Let the engine run at idle speed and turn the engine switch
on “STOP”.
4. Clean the machine with water and a brush.
5. If you do not expect to use the engine for a long period of time, drain the fuel tank
with fuel and let the engine run at idle speed until the fuel in the carburator is
used and the engine stops.
6. After use, place the HAL-200 on a dry and stable surface.
Summary of Contents for HAL200 H
Page 44: ...44 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 48: ...48 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 54: ...54 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
Page 56: ...56 59 Gebruikershandleiding User Manual Bedienungsanleitung HAL rev 1 2 17 05 2019...
