5/16
Operation manual
LHF/HS-ER,
edition 1.3: 06 -02-2019
``````
▪
Make sure that the working area is lightened well.
▪
Do not pull the plug out of the wall socket or extension lead by its lead.
▪
Check the feeder cable’s
outer casing
and if in use extension lead’s
outer casing before you connect the
machine to the electrical mains. The outer casing may not be damaged. Replace the cable if you cannot read
the marks on the outer casing anymore.
▪
Do not use the machine in an explosion endangered area.
▪
Regularly check the connections of the supply-cable to the switch.
▪
Ensure that the wall socket and possible connections between the extension leads are protected against
dampness.
▪
The PRCD will automatically switch off the machine, when the electrical power cuts off.
This prevents the machine from starting suddenly when the electrical power comes on again.
▪
Check the machine’s cable
-connections before you connect the machine to the electrical mains. The cables
must be properly connected.
▪
After use, place the poker vibrator on a stable and dry surface.
▪
When the poker vibrator is not being used for longer period, then it must be stored in a dry and clean area.
▪
When cleaning the poker vibrator, ensure that no water or cleaning detergent gets into the poker vibrator.
▪
Disconnect the electrical supply to the poker vibrator, before you start to clean or maintain the poker vibrator.
2.3 Rest risk
The manufacturer aimed for the best balance in functionality, safety and operation possibilities of the LHF/HS-ER.
Please take notice of the following rest:
for prolonged working with LHF/HS-ER poker vibrators it is obligated to
wear anti vibration gloves.
Well instructed operators with a correct working attitude concerning safe operating are well capable of working
safely with the LHF/HS-ER poker vibrator.
