•
LIFA Special Cleaner brushing machine
is connected to a single phase (1~)
current, 230 VAC (or 120 VAC),
50/60 Hz.
•
Protective switch for motor is equipped
with a low voltage protection which
prevents the switching on if the voltage
is too low or if there is no voltage.
•
Only authorised electrician may do
the repairs or installations of the
electrical components. In addition,
electrician must be authorised by the
manufacturer; otherwise the warranty
expires.
7. Noise level
The noise level of LIFA Special Cleaner is
low (70 dB) and it is not dependant of the
operating environment.
8. Transportation and operating position
During the transportation, the machine
must be tied firmly in order to prevent
any damage to the machine or people.
Before use make sure that all the compo-
nents are in place and that the machine
functions well. The machine must be
transported, used and stored in an up-
right position. The machine must be
positioned far enough from walls and
other obstacles and placed firmly and
straight. Ensure a free rotation of the
brush.
Ensure that the power supply is
reliably earthed.
Connect the device only to
grounded socket!!
the shaft and controls the rotating of the
brush.
4. Workplace conditions / overload
Make sure that the lightning, air condition-
ing, latter and trestles are sufficient. If the
brush generates static electricity or sparks
in the duct do not use these types of
brushes in the duct if there is any flamma
-
ble liquids, gases, dust or other sensitive
substances nearby. Use antistatic brushes
and safety ground by following the special
instructions in difficult conditions.
The permitted working temperature is
5–50 °C (41–20 °F). The gearing warms up
a bit when the machine is being used. If
the motor overheats or free rotation of the
brush has been prevented, the overheat
protection of the frequency converter
will be switched on automatically. When
the right working temperature has been
reached the motor will start working again.
The current must be switched off when it is
not being used.
5. The cleaning shaft
Check the condition of the cleaning
shaft before every use. Be careful not to
damage the shaft. If the shaft has been
damaged take immediate contact to your
local distributor. Minor scratches on the
shaft surface can be fixed by coating it
again with a heat shrinkable tube. During
storage and transportation, the cleaned
shaft must always be reeled into the drum.
6. Electrical connection
•
Ensure that the voltage supply and the
current responds to the information
stated in the CE-plate and the
information in the instructions.
5
