Power Switch
Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions: "l" (one) for ON and "0"
(zero) for OFF.
Immobilization Method
The purpose of immobilizing the treadmill is to prevent unauthorized use. The system causes immobilization of the
treadmill when a pre-defined hard key sequence has been activated.
1.
Set the display to read SELECT WORKOUT.
NOTE: Press the CLEAR key twice if not already there
2.
Hold down the SPEED DOWN key and press the PAUSE key.
The treadmill now displays IMMOBILIZED. In this state, the treadmill cannot be operated. The belt and incline motors
are disabled. The treadmill will remain in this state across resets, power cycles, etc. To restore normal operation, repeat
the same key sequence; hold down the SPEED DOWN key, and press the PAUSE key. The treadmill will display SELECT
WORKOUT again.
Page 12 of 33
Summary of Contents for Activate
