7
1.2
S
ETUP
Read the Operation Manual before setting up the Life Fitness Summit Trainer.
W
HERE TO
P
LACE THE
L
IFE
F
ITNESS
®
S
UMMIT
T
RAINER
Follow all safety instructions in Section 1.1 and move the Life Fitness Summit Trainer to the location in which it will be
used. See Section 7 for the dimensions of the footprint. Allow 1 foot of clearance in front of the Life Fitness Summit
Trainer to allow for movement of the total body arms.
H
OW TO
S
TABILIZE THE
L
IFE
F
ITNESS
S
UMMIT
T
RAINER
After placing the Life Fitness Summit-Trainer in position, check the unit for stability by attempting to rock the unit. Any
slight rocking indicates that the unit must be leveled. There are a total of (5) feet on the Summit Trainer for stability. The
(2) rear feet under the rear step should require no adjustment. The (1) middle leveler should be adjusted last and is only
for support, not leveling. Check the (2) front levelers to determine which foot does not rest fully on the floor. Rotate the
foot counter-clockwise to lower it. Recheck the stability and adjust again as needed until the unit is stable and no longer
rocks. Lower the middle leveler until it contacts the floor. Lock the adjustment nut on both the (2) front and middle levelers
by tightening the jam nut with a 17 mm wrench.
C
HECK FOR
P
OWER
The console is powered by a rechargeable 6-volt battery. Check the battery by pressing the START key. The console
should light up, and the MESSAGE CENTER should display a prompt to set up a workout. If this does not occur, mount
the Life Fitness Summit Trainer and begin pedaling. The console should then light up, making it possible to program a
workout. Pedal for 10 to 20 minutes at
0.5 mph (0.8 kph)
or faster during a workout to charge the battery. Afterwards, the
pedal action during workouts keeps the battery charged. If the console still does not light, contact Life Fitness Customer
Support Services
(see page one of this manual for more information)
.
F
ITNESS AND
E
NTERTAINMENT
N
ETWORKING
Two interchangeable network ports allow the Life Fitness Summit Trainer to be connected to a fitness entertainment sys-
tem or a network, such as FitLinxx
TM
interactive fitness network.
•
Networking:
The built-in networking ports allow the unit to exchange workout information with a fitness network
database.
•
Fitness Entertainment:
The network connection enables the console to power a third-
party receiver for use with a service such as the Cardio Theater
®
entertainment system
or the BroadcastVision
TM
entertainment system.
These ports are located on the back of the console and are enclosed by a removable cover.
Any use of the ports for other than their intended purpose could void the product warranty.
A
