12
5.
Remove the two SCREWS (9) securing the REAR CONSOLE COVER (10) to the frame. Remove the rear console
cover. Re move the TOP INSERT (11) from the rear console cover and discard. Set the rear console cover aside.
6.
Console Cable Connections
For 95T Elevation Inspire Units Only:
6a.
Carefully pull the MEDIA CABLE BUNDLE
(12)
(Power and Coaxial)
from inside the
CONSOLE BRIDGE (13). Un bundle and
straighten the media cables.
6b.
Install the coaxial extension coupler and
coaxial extension cable.
6c.
Connect the I-R REMOTE CONTROL (A)
and
VIDEO (B) CABLES to the back of the
DISPLAY CONSOLE (C).
6d.
Tape the ends of all CABLES
(Power,
Coaxial, I-R Remote Control, Video)
together.
For 95T Elevation Discover SI Units Only:
Note: Only the COAXIAL CABLE is inside the CONSOLE BRIDGE.
6a.
Attach the three MEDIA CABLES (12) to the back of the Discover SI CONSOLE (C) as shown below.
7.
Hold the MAIN BRACKET ASSEMBLY (4) close to the CONSOLE BRIDGE (13) as shown. With the holes facing
upward, feed the taped end of the MEDIA CABLES (12) through the bottom of the main bracket assembly and out of
the upper hole as shown. Carefully pull excess media cable through the main bracket assembly.
8.
Slide one GROMMET (14) over the taped end of the MEDIA CABLES (12). Install the grommet into the top access
hole.
9.
Tilt the MAIN BRACKET ASSEMBLY (4) upward and align the LOWER MOUNTING BRACKET (3) holes with those
in the console bracket posts. Secure the MAIN BRACKET ASSEMBLY using four SCREWS (5) and WASHERS
(6). Tighten the screws securely (8-10 ft. lbs.).
CAUTION:
Raise the BRACKET COVER (7) to meet the exiting MEDIA CABLES before mounting the MAIN BRACKET
ASSEMBLY.
C
A
B
13
12
14
4
6
5
11
10
9
C
14
4
6
5
11
10
9
12
13
Remote
High-Def
Treadmill Elevation Discover SI Console
Power
