18
10.
Attach the ATTACHABLE TV (q) to the UPPER MOUNTING
PLATE (r) using four SCREWS (s) and NYLON
WASHERS (t). Tighten the SCREWS to 6-8 in-lbs. Do not
overtighten the SCREWS.
11.
Connect the COAXIAL CABLE (e), REMOTE CABLE (h), &
POWER CORD (d) to the rear of the ATTACHABLE TV (q).
See the
Media Connections
pages in this manual for detailed
information.
12. Unwrap the MAIN WIRE HARNESS (D) located at the base of the LEFT UPRIGHT
(
1). Route the MAIN WIRE HARNESS, POWER CABLE and COAXIAL CABLE under the CROSS FRAME MEMBER
(E). Connect the 10-PIN CONNECTOR (10P) of the main wire harness to the corresponding JACK (F) located at the
top of the CONTROL BOARD (G). Connect the console connectors as instructed in the Assembly Instructions and
secure the FRONT CONSOLE (S) using the eight previously removed SCREWS (Q). Tighten the screws securely.
Note: All cables should be routed through the CABLE GUIDE (c) located at the
lower left of the REAR CONSOLE (R).
13. Locate the COAXIAL COUPLER (u). Remove the RETAINING NUT (v) and two
WASHERS (w & x) from the coupler. Insert the coupler into the large D-Slot
located at the front of the MOTOR PAN (y). Secure the coupler using the
two washers and retaining nut previously removed. Tighten the nut securely.
Attach the COAXIAL CABLE (e) leading from the left upright to
the top of the coupler. Attach the broadcast SUPPLY CABLE (z) to the
bottom of the coupler.
Note: Be sure to leave at least 12” of excess broadcast SUPPLY CABLE (z) between
the fl oor and the coaxial connection on the unit to accommodate elevation of the unit.
14. Remove the RETAINING NUT (aa) and WASHER (bb) from the coupler
end of the POWER CORD (d) leading from the left upright. Position the coupler into the small D-Slot located at the
front of the MOTOR PAN (y). Secure the coupler using the washer and retaining nut previously removed.
Tighten the nut securely. Mount the POWER ADAPTER (cc) to the bottom of the MOTOR PAN (y) using two
CABLE TIES (j). Be sure the cable ties are pulled tight and trim the excess
cable ties. Connect the screw-type connector of the POWER CORD (dd) to
the underside of the power cord coupler. Bundle excess power cord and
store under the unit.
Note: Be sure the POWER ADAPTER (cc) and CABLE TIES (j) do not
interfere with the lift mechanism.
15. Connect the power supply cord to the POWER ADAPTER (cc).
16. Continue with the remainder of assembly as instructed in the Assembly
Instructions. Plug the power supply cord into an electrical outlet upon
completion.
1
E
D
10P
F
G
n
j
t
x
aa
v
w
u
z
g
bb
cc
y
s
t
r
BB
AA
q
b
p
h
d
e
o
m
1
2
