29
Models:
95C/97C Upright Lifecycle® Exercise Bikes Elevation Inspire &
95C/97C Upright Lifecycle® Exercise Bikes Elevation Discover SI
Tools Required:
Phillips Screwdriver, Metric Allen Set, M16 & M17 Wrench
Parts Not Used From Kit:
(1) Lower Mounting Bracket
For 95C/97C Elevation Inspire Units Only:
a.
Remove the protective liner from one of the provided fastener
strips. Attach the fastener strip to the bottom of the POWER
BLOCK (1). Interlock the remaining fastener strip to the
installed fastener strip. Remove the remaining protective liner from
fastener strip and secure the power block to the underside of
the center frame as shown.
Connect the SCREW-TYPE CONNECTOR of the POWER CORD
(2) to the underside receptacle. Bundle excess power cord and
store under the unit. Connect the COAXIAL CABLE (3) to
the broadcast supply receptacle in similar fashion.
b.
Connect the POWER SUPPLY CORD to the POWER BLOCK (1).
1.
Attach the TV BRACKET
(with bent tab)
(4) to the MAIN BRACKET (5) as
shown using four SCREWS (6) and WASHERS (7). Tighten the screws
securely. (8-10 ft. lbs.)
2. Remove the four SCREWS (8) securing the REAR CONSOLE COVER (9)
to the frame. Remove the rear console cover.
Remove the four SCREWS (10) securing the INSERT (11) as shown. Set
the rear console cover aside.
Remove the CONSOLE (14).
1
2
3
4
7
6
5
8
11
9
14
10
