32
11.
Tilt the DISPLAY CONSOLE back into place. Replace the REAR
CONSOLE COVER (9) and secure it using the previously removed
four SCREWS (8). Tighten the screws securely. (8-10 ft. lbs.). Do not
overtighten the screws.
12. With the remaining TV BRACKET (20) oriented as shown, install it to
the back of the ATTACHABLE TV (21) using four SCREWS (22)
and WASHERS (23). Tighten the screws securely. (8-10 ft. lbs.)
Note: Be sure the side holes of the TV BRACKET are oriented as
shown.
13. Position the TV BRACKETS (4 & 20) together and secure them
using one BOLT (24), WASHER (25) and NUT (26). Leave the
bolt and nut loose at this time.
Note: Be sure the PIVOT POST of the TV BRACKET engages
onto TV BRACKET.
14. Connect all cables to their corresponding jacks located on the
bottom of the ATTACHABLE TV. See the
Media
Connections
pages in this manual for detailed information.
Feed any excess media cable into the MAIN BRACKET (5).
15. Align the lowest side holes on the TV BRACKETS (4 & 20). Secure the TV BRACKET into proper position using one
SCREW (27) on each side.
16. Plug in and power on the TV. Refer to the
ATTACHABLE TV
Operation Manual for proper TV setup.
For Achieve Console Units Only:
a.
Remove the two SCREWS (A) and WASHERS (B) securing the
BOTTOM INSERT (C). Remove the BOTTOM INSERT. Do not discard the SCREWS and WASHERS.
b.
Locate the REMOTE CONTROL (D) and REMOTE BRACKET (E). Feed the REMOTE CABLE (F) through the large
access hole in the REMOTE BRACKET (E). With the REMOTE
CONTROL (D) and REMOTE BRACKET (E) oriented as shown, secure
them together using one SCREW (G). Tighten the screw securely.
c.
Carefully feed the REMOTE CABLE (F) through the opening in the
bottom of the CONSOLE (H) and through the back of the console.
Position the REMOTE BRACKET (E) into position replacing t he
BOTTOM INSERT (C). Secure the REMOTE BRACKET using the
previously removed SCREWS (A) and WASHERS (B).
H
16
D
A
A
C
B
16
E
F
G
A
A
B
21
20
22
23
21
27
27
24
25
26
4
27
21
20
