35
Models:
95CI, 93C, & 90C
Tools Required:
Metric Hex Key Set, Side Cutters
Note: Proceed with the following steps before attaching the DISPLAY CONSOLE and ACCESSORY TRAY as described
in the 95Ci, 93C & 90C Assembly Instructions.
1.
Locate the SPACER (a). With the SPACER
oriented as shown, feed all the console
CONNECTORS, POWER CORD, and COAXIAL
CABLE through the large center hole in the
SPACER. Slide the SPACER onto the CONSOLE
MOUNTING PLATE (D) making sure the top of the
SPACER hooks over the top of the CONSOLE
MOUNTING PLATE. Align the mounting holes of the
SPACER and CONSOLE MOUNTING PLATE.
Run the POWER CORD, and COAXIAL CABLE
through the channel at the top of the SPACER.
2.
Locate the MOUNTING BRACKET (b). With the
MOUNTING BRACKET oriented as shown, feed
all the console CONNECTORS through the large
center hole in the MOUNTING BRACKET. Align the
LOCATING TABS (c) of the MOUNTING BRACKET
with the tab slots and position the
MOUNTING BRACKET into the center channel
of the SPACER. Slide the MOUNTING BRACKET
upward until it locks solidly in the SPACER. Secure
the MOUNTING BRACKET to the SPACER using
two FLAT HEAD SCREWS (d). Tighten the
SCREWS securely.
3.
Locate the REMOTE CONTROL (e). Remove the
two horizontal CABLE TIES (c-H) for a vertical (c-V)
installation.
4.
Remove the four SCREWS (2) securing the TOP POLAR COVER to the
BOTTOM POLAR COVER (6) and remove the top polar cover. Carefully pull the
lead end of each CABLE TIE (C-V) until the receptor end meets the bottom of the
REMOTE CONTROL (e).
5.
Locate the provided NEW TOP POLAR COVER (f) with mounting slots. Feed both
lead ends of the CABLE TIES (C-V) through the bottom mounting slots of the top
polar cover as shown. Loop the lead ends of the cable ties upward through the top
mounting slots. Feed the cable ties through until the bottom of the REMOTE
CONTROL (e) contacts the top polar cover.
6.
Feed the lead ends of the CABLE TIES (C-V) through the receptor ends and slowly
pull them tight, alternating between the two cable ties. The remote control should
now be snug against the TOP POLAR COVER (f). Trim the excess length of cable
ties.
7.
Install the NEW TOP POLAR COVER (f) to the BOTTOM POLAR COVER (6)
using the four previously removed SCREWS (2).
8.
Loop the REMOTE CABLE (g) under the HANDLEBARS (11) and secure it to the
top of the CONSOLE EXTENSION TUBE (h) using one CABLE TIE (j) at the location shown.
9.
Install the DISPLAY CONSOLE (4) and ACCESSORY TRAY (3) as instructed in the Assembly Instructions using the
four new 1-1/2” SCREWS supplied. Tighten the SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
CAUTION:
Do not pinch any wires when assembling the DISPLAY CONSOLE (4) to the console MOUNTING plate (D).
d
a
2
E
D
4
b
c
a
e
e
f
C-V
g
h
j
11
4
f
11
g
6
2
