43
Models:
95RI, 93RI, & 90R
Tools Required:
Metric Hex Key Set, Side Cutters
Note: Proceed with the following steps before attaching the DISPLAY CONSOLE as described in the 95Ri, 93Ri, 90R
Assembly
Instructions.
1.
Locate the SPACER (a). With the SPACER oriented as
shown, feed all the console CONNECTORS, POWER
CORD, and COAXIAL CABLE through the large center
hole in the SPACER. Slide the SPACER onto the
CONSOLE MOUNTING PLATE (b) making sure the top of
the SPACER hooks over the top of the CONSOLE
MOUNTING PLATE. Align the mounting holes of the
SPACER and CONSOLE MOUNTING PLATE. Run the
POWER CORD, and COAXIAL CABLE through the channel
at the top of the SPACER.
2.
Locate the MOUNTING BRACKET (c). With the
MOUNTING BRACKET oriented as shown, feed all the
console CONNECTORS through the large center hole in the MOUNTING
BRACKET. Align the LOCATING TABS (d) of the MOUNTING BRACKET with
the tab slots and position the MOUNTING BRACKET into the center channel
of the SPACER. Slide the MOUNTING BRACKET upward until it locks solidly
in the SPACER. Secure the MOUNTING BRACKET to the SPACER using
two FLAT HEAD SCREWS (e). Tighten the SCREWS securely.
3.
Locate the REMOTE CONTROL (f). Confi gure the remote control for a
vertical (c-V) installation. Secure the REMOTE CONTROL to the top of the
HANDLEBAR (g) as shown. Be sure the CABLE TIES (c-v) are pulled tight
and trim the excess cable ties.
4.
Loop the REMOTE CABLE (h) under the HANDLEBAR (g) and secure it to the
HANDLEBAR using three CABLE TIES (j) at the locations shown.
5.
Install the DISPLAY CONSOLE (7) as instructed in the Assembly Instructions using the four new 1-1/2” SCREWS
supplied. Tighten the SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS.
CAUTION:
Do not pinch any wires when assembling the DISPLAY CONSOLE (7) to the console MOUNTING plate (b).
6.
Attach the ADAPTER BRACKET (AA) to the ATTACHABLE TV (k) to the using four SCREWS (BB). Tighten the
SCREWS to 6-8 in-lbs. Do not overtighten the SCREWS. Attach the ATTACHABLE TV to the UPPER
MOUNTING PLATE (m) using four SCREWS (n) and washers (o). Tighten the SCREWS to 6-8 in-lbs. Do not over
tighten the SCREWS.
e
a
c
d
a
7
4
b
10P
4P
g
b
f
h
j
o
m
n
k
BB
AA
