Life Fitness OST, Assembly Instructions Manual

Power Switch

Located on the front panel at the base of the treadmill, the ON/OFF switch has two positions: "I" (one) for ON and "0"
(zero) for OFF.

Power Cord Routing

WARNING: Make sure the power cord is unplugged before attempting to route it around or through the
treadmill.

Connect the power cord to the power receptacle in the front of the treadmill. The power cord can be run to the user-
front left or right sides depending on installation / site needs.

NOTE: To accommodate treadmill incline, at least 2 ft. (24”) of power cord is required between the outlet and the last
power cord clip for outlets in front of the treadmill.

WARNING: Keep the area 6.5 ft. (2 m) by 3 ft. (0.9 m) behind the treadmill clear of any obstructions, including
walls, furniture, and other equipment. Contact Customer Support Services for an optional longer power cord if
necessary.
DANGER: Ensure that the power cord does not contact the striding belt or get pinched between the frame, lift
arm or under the wheels; failure to follow this warning may result in serious injury.

Item

Description

1

Power Receptacle

2

Frame

3

Wheel

4

Lift Arm

5

Striding Belt

Immobilization Method

The purpose of immobilizing the treadmill is to prevent unauthorized use. The system causes immobilization of the
treadmill when a pre-defined hard key sequence has been activated.

1.

Set the display to read 

SELECT WORKOUT

.

NOTE: Press the 

CLEAR

 key twice if not already there

2.

Hold down the 

SPEED DOWN

 key and press the 

PAUSE

 key.

The treadmill now displays 

IMMOBILIZED

. In this state, the treadmill cannot be operated. The belt and incline motors

are disabled. The treadmill will remain in this state across resets, power cycles, etc. To restore normal operation,
repeat the same key sequence; hold down the 

SPEED DOWN

 key, and press the 

PAUSE

 key. The treadmill will display

SELECT WORKOUT

 again.

Page 8 of 23