8.
Locate the LEFT HANDRAIL (9). With the plastic trim facing
upward, slide the LEFT HANDRAIL into the LEFT HANDRAIL
BRACKET (J) located on the CONSOLE BRIDGE (5). Secure
the LEFT HANDRAIL using two BOLTS (2) and WASHERS
(3) from the side as shown. Leave the BOLTS loose at this
time.
Repeat to install the RIGHT HANDRAIL (10).
9.
Install the RIGHT and LEFT END GASKETS (11
& 12) onto the ERGO CROSSBAR (13).
The GASKETS are marked with an “L”
(left) or “R” (right) as well as an arrow indi-
cating the “UP” position.
10.
Install the ERGO CROSSBAR (13) to the
HANDRAILS (9 & 10) and CONSOLE BRIDGE (6)
using four SCREWS (14), three SCREWS (39) and
seven WASHERS (10). Do not overtighten the SCREWS.
NOTE:
ROUTE THE HEART RATE CABLES (L)
UNDER THE MOUNTING TABS AS SHOWN.
BE CAREFUL NOT TO DAMAGE THE
HEART RATE CABLES.
11.
Secure the tops of the HANDRAILS (9 &
10) using two SCREWS (39) and WASH-
ERS (8) at each HANDRAIL. Tighten the
SCREWS securely.
12.
Tighten all previously installed six UPRIGHT
(2), six BRIDGE (2) and seven ERGO CROSS-
BAR SCREWS (39 & 14) securely.
@
@
NOTE:
PUSH DOWN ON THE FAR ENDS OF THE
HANDRAILS TO VERIFY ALL SCREWS ARE LOCKED IN
PLACE.
13.
From under the CONSOLE BRIDGE (5), install the MAS-
TER WIRE HARNESS (15) to the CONSOLE (D)
and HEART RATE (L) CABLES. WIRE-TIE (M)
the cables to the CONSOLE BRIDGE as
shown.
Feed the combined connector upward to the
back of the CONSOLE BRACKET (6).
Attach the FERRITE (W) to the inside of the
user left CONSOLE BRACKET POST (X).
Carefully secure the MASTER WIRE HARNESS to
the
CONSOLE BRACKET using CABLE TIES (40)
14.
Connect the C-SAFE EXTENSION CABLE (Y) to the
C-SAFE SPLITTER (Z).
15.
Slide the TOP COVER (16) over the CONSOLE
BRACKET (6) and onto the CONSOLE BRIDGE (5).
Secure it using six SCREWS (7). Tighten the
SCREWS securely.
NOTE:
BE SURE THE TOP COVER FULLY SEATS
INTO THE ERGO CROSSBAR GASKETS.
16.
Locate the RIGHT OUTER HANDRAIL COVER (17).
Align it onto the RIGHT HANDRAIL (10) as shown and secure
using six SCREWS (7). Tighten the SCREWS securely.
NOTE:
ONE SCREW IS LOCATED AT THE FRONT OF THE
UNIT.
Repeat for the LEFT OUTER HANDRAIL COVER (18).
17.
Locate the RIGHT INNER HANDRAIL COVER (19). Align it
onto the RIGHT HANDRAIL (10) as shown and secure
using five SCREWS (7). Tighten the SCREWS securely.
NOTE:
BE SURE TO ENGAGE THE TOP TABS UNDER
THE PLASTIC RAIL OF THE RIGHT HANDRAIL.
Repeat for the LEFT INNER HANDRAIL COVER (20).
10
2
3
9
13
8
14
8 39
14
8
39
8
J
5
11
12
D
X
H
M
E
5
L
W
15
Z
6
Y
G
L
13
N
