1. Assemble together the CENTER FRAME (1), SUPPORT LEG (2), and CENTER
SUPPORT (3) using six M10 X 25mm BOLTS (4), ten 3/8" SAE WASHERS (5), and
four M10 NYLOCK NUTS (6), as shown. Tighten all BOLTS and NUTS securely.
2. Loosely attach the RIGHT UPRIGHT (7) and LEFT UPRIGHT (8) onto the CENTER
FRAME (1) using two M10 X 85mm BOLTS (9), four 3/8" SAE WASHERS (5), and
two M10 NYLOCK NUTS (6), as shown.
Loosely attach the RIGHT UPRIGHT (7) and LEFT UPRIGHT (8) onto the CENTER
SUPPORT (3) using two M10 X 65mm BOLTS (10), four 3/8" SAE WASHERS (5),
and two M10 NYLOCK NUTS (6), as shown.
Tighten all BOLTS and NUTS securely.
3. Slide one ROLLER PAD (11) onto the LEFT PAD SHAFT (A) until it contacts the
pre-installed SHAFT COLLAR (B). Secure the ROLLER PAD using one FENDER
WASHER (12) and one M10 X 25mm BOLT (4). Tighten the BOLT securely. Insert
one ROLLER PAD CAP (13) onto the ROLLER PAD as shown.
Repeat this procedure to install the remaining ROLLER PAD onto the RIGHT PAD
SHAFT.
4. Attach one KNEE PAD (14) to the LEFT KNEE SUPPORT BRACKET (C) using three
M10 X 25mm BOLTS (4) and three 3/8" SAE WASHERS (5). Tighten all BOLTS
securely.
Repeat this procedure to install the remaining KNEE PAD onto the RIGHT SUPPORT
BRACKET.
