1.3 S
ETUP
Read the Operation Manual before setting up the Life Fitness Summit Trainer.
E
LECTRICAL
P
OWER
R
EQUIREMENTS
The Life Fitness Summit Trainer requires an AC power supply according to the electrical config-
urations listed in the chart below.
NOTE:
Do not modify the plug provided with this product. If the plug does not fit into an available
electrical outlet, have a proper outlet installed by a qualified electrician.
W
HERE TO
P
LACE THE
L
IFE
F
ITNESS
S
UMMIT
T
RAINER
Following all safety instructions in Section 1.1, move the Life Fitness Summit Trainer to the
location in which it will be used. See Section 7, titled
Specifications,
for the dimensions of the
footprint. Allow one foot of clearance in front of the Life Fitness Summit Trainer to allow for
movement of the total-body arms.
H
OW TO
S
TABILIZE THE
L
IFE
F
ITNESS
S
UMMIT
T
RAINER
After placing the Life Fitness Summit Trainer in position, check the unit for stability by attempting to
rock the unit. Any slight rocking indicates that the unit must be leveled. There are a total of (5) feet on
the Life Fitness Summit Trainer for stability. The (2) rear feet under the rear step should require no
adjustment. The (1) middle leveler should be adjusted last and is only for support, not leveling. Check
the (2) front levelers to determine which foot does not rest fully on the floor. Rotate the foot counter-
clockwise to lower it. Recheck the stability and adjust again as needed until the unit is stable and no
longer rocks. Lower the middle leveler until it contacts the floor. Lock the adjustment nut on both the
(2) front and middle levelers by tightening the jam nut with a 17 mm wrench.
8
Supply Voltage
(VAC)
100
110
120
200
220
230
240
Frequency
(Hz)
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
50 / 60
Rated Current
(Amps)
1.6
1.6
1.6
.8
.8
.8
.8