3.9
C
ONNECT ALL
C
ONSOLE
W
IRING
; C
ONSOLE TO
C
ONSOLE
B
RACKET
;
B
ACK
P
LASTIC
S
HELL
Parts:
Hardware Bag #6
(4, M5 X 12mm Black Phillips Screws)
(4, M3.5 X 8mm Clear Zinc Screws)
Tools:
Phillips Screwdriver
Position the console (Q) close to the console bracket (P) and follow the
below instructions to connect all wiring.
Plug cables into the back of the display console:
1. Plug the 15-pin connector at the end of the upper wire harness into
the 15-pin connector (15P) in the back of the display console.
Make sure the connector snaps into place.
2
Plug the 4-pin connector at the end of the contact heart rate sensor
cable to the 4-pin cable (4P) located in the console.
3.
Plug in the flat 13-pin connector for the Coach Zone.
4.
Push excess cables into the opening of the upright tube assembly.
5.
Plug the ground cable (green wire, single spade) from the product
base to any of the three metal ground terminals (G) in the Go
Console, or into the connector (G) leading from the back of the
Track Console.
Line up the four holes in the console bracket with the four holes in the
back of the display console. Attach the display console using four
M5 X 12mm Black Phillips Screws (14). Be careful not to pinch cables
between the console and the console bracket. Be sure to get each
screw started before fully tightening.
Note:
To avoid stripping, do not overtighten the screws.
Attach the plastic shell (R) that covers the steel bracket in the back of
the console using four M3.5 X 8mm Clear Zinc Screws (15).
3.10 P
LUG IN THE
U
NIT
Parts:
Electric Transformer
Plug the black cord into the back of the machine and into a household electrical outlet
.
13
15P
4P
G
13P
14
Q
R
15
13P
4P
15P
G
Track Console
Connections
Go Console
Connections
