Removing the Regular Resusci
®
Junior* Chest Skin
In order to install our Child Defibrillation
Chest Skin, you must first remove the
outer skin that is currently in place on
your CPR manikin.
1. Unhook the chest skin from the
sides and fold it up over the head.
2. Lift out the lung plate.
3. Remove the lung bag system from
the Resusci
®
Junior* body.
Figure 3
4. Lift out the chest plate and remove
the roll of bags.
(See figure 3.)
Note:
The lung bag roll cannot be
reinstalled when the load box is in
place. The lung bags will have to be
set up one at a time.
5. Detach the rubber tether strap from
the pin at the base of the neck.
Figure 4
6. Turn the body over and remove
the four screws that hold the two
halves of the upper body together.
These are located across the back
of the shoulders.
(See figure 4.)
Figure 5
7. Lift the top half of the body slightly
away from the bottom, releasing
the tab that holds the neck in place.
(See figure 5.)
8. Remove the head and neck from
the body and remove the chest skin.
Figure 6
Installing the Load Box
(See figure 6.)
The next step is to install the load box
for the defibrillation chest skin. The
load box is the box attached to the
skin via one large cable and a smaller
cable with four lead snaps attached.
This is the device that will absorb the
energy being administered to the
chest skin during defibrillation.
Note:
It is very important that this
load box is installed properly!
*RESUSCI
®
JUNIOR IS A TRADEMARK OF LAERDAL MEDICAL CORPORATION.
2
Note:
If the defibrillation chest skin
is not functioning or wiring comes
undone, please contact us to repair or
replace the unit. Failure to do so, or
unauthorized repair, may void the war-
ranty or cause further harm or dam-
age to you or your equipment.
Accessories
LF03656U
Physio Control
Defribrillation Pad and
Patient Simulator
Adapter Package for
LifePak 10 and Lifepak 20
LF03657U
Marquette Electronics
Defribrillation Pad and
Patient Simulator Adapter
Package
LF03658U
SpaceLabs/Laerdal/
Heartstart/First Medic
Defibrillation Pad
and Patient Simulator
Adapter Package
LF03961U
Zoll Training Cables with
Adapters
LF03962U
Physio Control Training
Cables with Adapters
for LifePak 12
If you need help selecting the training
pad adapters that correspond to your
AED unit, please feel free to call us at
1-800-558-9595 for assistance.
5
NP016_96_LF03611 3
NP016_96_LF03611 3
10/5/12 10:24:12 AM
10/5/12 10:24:12 AM
