9
3. Handlebar Post and Tension Control Knob Installation
Remove four M8x10 Bolts (39), four Ø16xØ8x1.5 Washers (38), one M8x15 Bolt (24), and
one Ø20xØ8xδ1.5 Curve Washer (37) from the Main Frame (1). Remove bolts with the S6
Allen Wrench provided.
Slide the Handlebar Post Cover (31) up to the Handlebar Post (3).
Insert the Tension Cable (54) through into the bottom hole of Handlebar Post (3) and pull it
out from the square hole of Handlebar Post (3).
Connect the Sensor Wire (26) from the Main Frame (1) to the Extension Sensor Wire (59)
from the Handlebar Post (3).
Insert the Handlebar Post (3) onto the tube of the Main Frame (1) and secure with four
M8x10 Bolts (39), four Ø16xØ8x1.5 Washers (38), one M8x15 Bolt (24), and one
Ø20xØ8xδ1.5 Curve Washer (37) from the Main Frame (1) that were removed. Tighten
bolts with the S6 Allen Wrench provided. Slide the Handlebar Post Cover (31) down to the
Main Frame (1).
Remove the Ø5xØ20xδ1.5 Big Washer (46) and M5x20 Bolt (57) from the Tension Control
Knob (7). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (7) into the spring hook of
Tension Cable (54) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (7) up and force it into the gap of metal bracket of Tension Cable (54) as shown
in drawing B of figure 3. Attach the Tension Control Knob (7) onto the Handlebar Post (3)
with the Ø5xØ20xδ1.5 Big Washer (46) and M5x20 Bolt (57) that were removed. Tighten
bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Allen Wrench S6
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
1
3
46
57
7
54
59
59
39
26
37
24
39
38
31
54
38
A
B
54
54
7
7
