Life Gear 20460A, Owner'S Manual

9

 
3. Handlebar Post and Tension Control Knob Installation

Remove four Ø8xØ25 Big Curve Washers (33) and four M8x15 Bolts (51) from the Main 
Frame (1).    Remove bolts with the S5 Allen Wrench provided.     
Connect the Sensor Wire (53) from the Main Frame (1) to the Extension Sensor Wire (59) 
from the Handlebar Post (2).   
Put the cable end of resistance cable of Tension Control Knob (49) into the cable lock of 
Tension Cable (60), see Figure A.     
Pull the resistance cable of Tension Control Knob (49) up and force it into the slot of metal 
bracket of Tension Cable (60), see Figure B.     

Insert the metal fitting on the 

resistance cable of Tension Control Knob (49)

into the hole at 

the end of the slot in the

 metal bracket of Tension Cable (60), see Figure C. 

Connect the resistance cable of Tension Control Knob (49) to Tension Cable (60) complete, 
see Figure D. 
Insert the Handlebar Post (2) onto the tube of the Main Frame (1) and secure with four 
Ø8xØ25 Big Curve Washers (33) and four M8x15 Bolts (51) that were removed.    Tighten 
bolts with the S5 Allen Wrench provided.   
   

Allen Wrench S5 

Tool: 

A 

B 

C 

D