9
3. Front Handlebar Post, Tension Control Knob, and Foot Pedals Installation
Remove one Ø8xØ20x2 Big Curve Washer (4), one M8x15 Bolt (72), four M5x20 Bolts (35)
and four Ø8 Washers (36) from the tube of the Front Main Frame (21). Remove bolts with
the S6 Allen Wrench provided.
Slide the Front Handlebar Post Cover (41) up to the Front Handlebar Post (34).
Insert the Tension Cable (31) through into the bottom hole of Front Handlebar Post (34) and
pull it out from the square hole of Front Handlebar Post (34).
Connect the Extension Hand Pulse Sensor Wires I (70) and Sensor Wire (71) from the Front
Main Frame (21) to the Extension Hand Pulse Sensor Wires II (27) and Extension Sensor
Wire (26) from the Front Handlebar Post (34).
Insert the Front Handlebar Post (34) onto the tube of the Front Main Frame (21) and secure
with one Ø8xØ20x2 Big Curve Washer (4), one M8x15 Bolt (72), four M5x20 Bolts (35)
and four Ø8 Washers (36) that were removed. Tighten bolts with the S6 Allen Wrench
provided.
Slide the Front Handlebar Post Cover (41) down to the Front Main Frame (21).
Remove the Ø5xØ20x1.5 Big Washer (32) and M5x20 Bolt (33) and from the Tension
Control Knob (30). Remove bolt with the Multi Hex Tool with Phillips Screwdriver provided.
Put the cable end of resistance cable of Tension Control Knob (30) into the spring hook of
Tension Cable (31) as shown in drawing A of figure 3. Pull the resistance cable of Tension
Control Knob (30) up and force it into the gap of metal bracket of Tension Cable (31) as
shown in drawing B of figure 3. Attach the Tension Control Knob (30) onto the Front
A
30
12
69
13
21
41
31
31
30
34
33
32
70
71
35
36
4
72
35
36
27
26
B
A
30
30
31
31
Tool:
Allen Wrench S6
Multi Hex Tool with Phillips Screwdriver
S8, S13, S14, S15
