14
OPERATING THE COMPUTER
SPECIFICATIONS:
TIME --------------------------------------------------- 0:00-99:59 MIN: SEC
SPEED ------------------------------------------------ 0.0-999.9 KM/H
DIST (DISTANCE) --------------------------------- 0.00-99.99 KM
CAL (CALORIES) ---------------------------------- 0.0-999.9 KCAL
ODO (ODOMETER) ------------------------------- 0.00-99.99 KM
(PULSE) ------------------------------------------ 40-240 BEATS/MIN
USING YOUR COMPUTER
The computer can be activated by pressing the buttons or by pedaling. If you leave the
equipment idle for approximately 4 minutes, the power will turn off automatically.
BUTTON FUNCTIONS:
MODE:
Press the MODE button to select each function of the computer.
Press and hold the MODE button for 3 seconds to reset all data values to zero except the
ODO (ODOMETER) data values.
SET:
Press the SET button to set data values of TIME, DISTANCE, or CALORIES for target
pre-setting.
RESET:
Press the RESET button to clear data values of TIME, DISTANCE, or CALORIES to
zero.
Press the RESET button to clear data values of TIME, DISTANCE, or CALORIES to zero for
target pre-setting.
COMPUTER FUNTIONS:
SCAN:
Press the MODE button until the screen displays SCAN, the computer will
automatically scan each function in sequence with change every 6 seconds.
TIME:
Displays your elapsed workout time in minutes and seconds. You may also pre-set
target time in STOP mode before training. To set TIME press the MODE button until you
see the TIME on the screen. Press the SET button, TIME begins blinking. Press the SET
button to change the time, each time you press the SET button TIME should change by 1
minute. Press the RESET button to clear the target time to zero. The pre-set target time
range is from 00:00 to 99:00 minutes. Once you pre-set target time and then start to
exercise, time starts counting down from pre-set target time to 0:00 per 1 second backward.
When the pre-set target time counts down to 0:00, time will start to count up immediately and
the computer will begin beeping to remind you.
SPEED:
Display the current training speed.
