10
Connect the Hand Pulse Sensor Wire (28) from the Handlebar Support Tube (4) to the
Sensor Wire I (58) from the Handlebar (5).
Connect the Hand Pulse Sensor Wire (28) and Sensor Wire II (60) from the Handlebar
Support Tube (4) to the Sensor Wires I (58) from the Handlebar (5).
Install the Handlebar (5) to the Handlebar Support Tubes (4) by inserting the Handlebar (5)
into the Handlebar Support Tubes (4), using one M6x35 Bolt (24) and two M6x15 Bolts (31).
Tension bolts partially with the #5 Allen Wrench.
IMPORTANT: While sliding the Handlebar (5) into the Handlebar Support Tubes (4),
make sure the wires are not outside of the Handlebar (5) perimeter and pay attention
not to pinch the wires when joining.
Remove two M5x15 Bolts (26) from the Computer (25). Connect the Sensor Wires I (58)
from the Handlebar (5) to the wires that come from the Computer (25).
Attach the Computer (25) onto the plate of the Handlebar (5) with two M5x15 Bolts (26) that
were removed. Tension bolts partially with the Multi Hex Tool with Phillips Screwdriver
provided.
NOTE: DO NOT FULLY TIGHTEN HARDWARE IN STEP 3 UNTIL STEP 4 IS
COMPLETED.
Hardware:
(24) Bolt M6x35
1 PC
(31) Bolt M6x15
6 PCS
