12
OPERATING THE COMPUTER
SPECIFICATIONS:
TMR (TIMER) ---------------------------------------- 00:00-99:59 MIN: SEC
SPD (SPEED) --------------------------------------- 0.0-999.9 KM/H
DST (DISTANCE) ----------------------------------- 0.00-99.99 KM
TOTAL (ODOMETER) ----------------------------- 0.00-99.99 KM
CAL (CALORIES) ----------------------------------- 0.0-999.9 KCAL
PULSE ------------------------------------------------- 40-200 BEATS/MIN
USING YOUR COMPUTER
The computer can be activated by pressing the key or by receiving the signal from the
speed sensor. If you leave the equipment idle for 4 minutes, the power will turn off
automatically.
KEY FUNCTIONS:
MODE:
Press the MODE key to select each function of computer.
By press and holding the MODE key for 3 seconds, all functional values will reset to zero
except the TOTAL (ODOMETER) function.
SET:
Press the SET key to set functional values of TIME, DISTANCE, or CALORIES for
target pre-setting.
RESET:
Press the RESET key to reset functional values of TIME, DISTANCE, or CALORIES
to zero for target pre-setting.
COMPUTER FUNTIONS:
SCAN:
Press the MODE key until the screen displays SCAN, the computer will automatically
Alternate the display of TMR, SPD, DST, TOTAL, and CAL in sequence, and will change the
presented image every 4 seconds.
TMR (TIMER):
Press the MODE key until the screen displays TMR, the computer will display
your elapsed workout time in minutes and seconds. When you start to exercise, time starts
counting up from 0:00 to 99:59 minutes in 1 second increments. You may also pre-set
target time before training when STOP appears on the screen. Press the MODE key to
select TMR function and then press the SET key to pre-set target time. You may press the
RESET key to reset the target values of TIME to zero. The pre-set target time range is from
0:00 to 99:00 minutes. Once you pre-set target time and then start to exercise, time starts
counting down from pre-set target time to 0:00 per 1 second backward. When the pre-set
target time counts down to 0:00, time will start to count up immediately and the computer will
begin beeping to remind you.
SPD (SPEED):
Press the MODE key until the screen displays SPD, the computer will
display the current training speed.
