13
DST (DISTANCE):
Press the MODE key until the screen displays DST, the computer will
display the accumulative distance traveled during workout. When you start to exercise,
distance starts counting up from 0.00 to 99.99km per 0.01km increment. You may also
pre-set target distance before training when STOP appears on the screen. Press the
MODE key to select DST function and then press the SET key to pre-set target distance.
You may press the RESET key to reset the target values of DISTANCE to zero. The pre-set
target distance range is from 0.00 to 99.90km. Once you pre-set target distance and then
start to exercise, distance starts counting down from pre-set target distance to 0.00. When
the pre-set target distance counts down to 0.00, distance will start to count up immediately
and the computer will begin beeping to remind you.
TOTAL (ODOMETER):
Press the MODE key until the screen displays TOTAL, the computer
will display the total accumulative distance traveled. The TOTAL function can not be reset
to zero by pressing and holding the MODE key for 3 seconds. If you take out the batteries
from the computer, the TOTAL function will reset to zero.
CAL (CALORIES):
Press the MODE key until the screen displays CAL, the computer will
display the total accumulated calories burned during workout. When you start to exercise,
calories start counting up from 0.0 to 999.9 calories. You may also pre-set target calories
before training when STOP appears on the screen. Press the MODE key to select CAL
function and then press the SET key to pre-set target calories. You may press the RESET
key to reset the target values of CALORIES to zero. The pre-set target calories range is
from 0.0 to 999.0 calories. Once you pre-set target calories and then start to exercise,
calories start counting down from pre-set target calories to 0.0. When the pre-set target
calories count down to 0.0, calories will start to count up immediately and the computer will
begin beeping to remind you. (This data is a rough guide for comparison of different
exercise sessions and should not be used in medical treatment).
PULSE:
Computer will display your current heart rate figures after you hold both two hands
on handlebar grip sensors during exercise. To ensure the pulse readout is more precise,
please always hold on to the handlebar grip sensors with both hands instead of just with one
hand when you try to test your heart rate figures.
HOW TO INSTALL THE BATTERIES:
1. Remove the battery cover on the back of the computer.
2. Place two size AA batteries into the battery housing.
3. Insure batteries are correctly positioned and battery springs are in proper contact with
batteries.
4. Re-install the battery cover.
5. If the display is illegible or only partial segment appears, remove the batteries and wait
15 seconds before reinstalling.
