16
the handlebar with both hands. Then use your left foot to run on the left side of the running
belt. You should see the running belt start to correct itself by moving back towards the
center. However, if the running belt is still shifting to the right, use the Allen Wrench
provided and turn the right Rear Roller Adjustment Bolt 1/2 turn in a clockwise direction.
Then try running on the center of the running belt again. If the running belt is still shifting to
the right, turn the right Rear Adjustment Bolt another 1/4 turn in the clockwise direction.
Then try running on the center of the running belt again. You should see the belt start to
correct itself by moving back towards the center. Repeat this procedure until the running
belt is centered.
If the running belt is slipping during use, then use the Allen Wrench provided and turn both
left and right Rear Roller Adjustment Bolts 1/4 turn in the clockwise direction. You should
now run on the running belt to determine if the running belt is still slipping. Repeating the
above procedure until the running belt is not slipping.
LUBRICATE BELT
The treadmill has already been spread with "Silicone Oil" in advance before leaving the
manufacturing plant. Silicone oil is without volatility and has gradually permeated through
the running belt. There will be no need to re-spread the oil in normal circumstances.
"Silicone Oil" may be re-spread once the resistance has been increased and the running belt
starts rubbing against the running deck. To hold open the running belt from two sides,
apply the silicone oil with an even motion on the center of the running deck. Allow the
silicone oil to ‘set’ for one minute before using the magnetic treadmill.
Attention:
Only use "Silicone Oil" lubricants for this equipment.
In addition, do not add
any other oil ingredient; otherwise the magnetic treadmill will be damaged. Do not
over-lubricate the running deck. Excess lubricant should be wiped off with a clean
towel.
